Balance Shaft Intake Side, Removing And Installing: Installing

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

-- Lubricate the balance shaft mountings -arrows- with engine oil.

Fig 1: Locating Balance Shaft Mountings

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the intake side balance shaft and tighten the bolt -2-.

Fig 2: Identifying Intake Camshaft Balance Shaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the O-ring -1- and coat with engine oil.

Fig 3: Bearing Pins Installation Position

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Coat the mounting pin with engine oil and insert it. The alignment pin -arrow- for the mounting pin must engage in the hole in the cylinder block.

NOTE:

Always replace the intermediate sprocket. Otherwise the backlash will not adjust itself and it could result in engine damage.

The new intermediate sprocket has an anti-friction coating that wears off after a short period of use, which automatically adjusts the backlash.

-- Mark the tooth face on the intermediate sprocket -arrows-.

Fig 4: Identifying Tooth Face On Intermediate Shaft Sprocket Marked With Paint

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the intermediate sprocket; the marking on the balance shaft must be between the markings on the tooth faces.

-- Tighten the bolt -1- for the intermediate sprocket: tightening sequence. Refer to Fig 5.

Fig 5: Identifying Intermediate Shaft Sprocket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Fig 6: Identifying Intermediate Shaft Sprocket

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Check the markings on the intermediate sprocket/balance shaft -arrow-.

Assemble in reverse order of disassembly. Note the following:

-- Install the balance shaft drive chain. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .

-- Install camshaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .

-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the upper timing chain cover. Refer to UPPER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Replace the intake side balance shaft seal. Refer to BALANCE SHAFT SEALING RING, REPLACING, INTAKE SIDE .

-- Install the toothed belt on the coolant pump. Refer to COOLANT PUMP TOOTHED BELT, REMOVING AND INSTALLING .