SUBFRAME Mount, Checking Adjustment

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

The following dimensions must be attained:

Fig 1: Identifying Distance And Dimension

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
The casting edge on the engine support must be parallel to the support arm
Dimension -b- = Dimension -b-.

NOTE:

Distance -a- can also be checked using a suitable round stock.

-- The distance measured is too small or too large, adjust the subframe. Refer to SUBFRAME MOUNT, ADJUSTING .