Overview - SUBFRAME Mount
WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to Fig 2.
- Engine Support
- Removing and installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
- Engine Mount
- With support arm
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 40 Nm + 90° turn
- Replace after removing
- Bolt
- 20 Nm + 90° turn
- Replace after removing
- Bolt
- 40 Nm + 90° turn
- Replace after removing
- Bolt
- 60 Nm +90° turn
- Replace after removing
- Pendulum Support
- Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Replace after removing
- Tightening specification and sequence. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- 60 Nm + 90° turn
- Replace after removing
- Bolt
- 60 Nm + 90° turn
- Replace after removing
- Transmission Mount
- With support arm
- Removing and installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
- Bolt
- 50 Nm + 90° turn
- Replace after removing