Engine, Securing On Engine And Transmission Holder

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Engine Sling: 2024A
Shop Crane: VAS6100
Engine And Transmission Holder: VAS6095

Procedure

The transmission is separated from the engine. Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- Unlock the retaining tab in direction of -arrow-, remove the left engine cover mount -1-.

Fig 1: Identifying Engine Cover Mount

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the right engine cover mount -1-.

Fig 2: Identifying Engine Cover Mount And Locating Bore

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Hook the : 2024A to the engine and to the : VAS6100 .

Fig 3: Engine Lifted

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To be aligned to the center of gravity of the engine assembly, the hole rails must be inserted as shown in the illustration.

-- Secure the mounting hooks and pins on the engine support bridge using securing pins -arrows-.

-- Lower the engine from the : VAS6931 using the : VAS6100 .

-- Remove the transmission alignment sleeve and secure the transmission side of the engine on the : VAS6095 .

Fig 4: Identifying Engine And Transmission Holder

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.