Overview - Oil Pan/Oil Pump
WARNING: This page is about a different variant/trim than selected.
NOTE:
If large quantities of metal particles or other deposits such as those caused by partial seizure of the crankshaft or connecting rod damage are found in the engine oil, clean the oil channels thoroughly and replace the engine oil cooler to prevent subsequent damage.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and Installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- O-Ring
- Replace after removing.
- Coat with engine oil
- Oil Drain Plug
- 30 Nm
- Seal
- Replace the gasket after removal
- Sealant
- Silicone grease. Refer to the Parts Information.
- Bolt
- 4 Nm +45°
- Replace after removing.
- For the oil baffle and oil intake pipe
- Oil Baffle
- If the oil pan upper section is replaced, the oil baffle must also be replaced.
- O-Ring
- Replace after removing.
- Coat with engine oil
- Oil Intake Pipe
- Clean the screen if there are debris
- Centering Bracket
- Bolt
- Tightening sequence. Refer to Fig 2.
- Replace after removing.
- Oil Pan Upper Section
- Tightening sequence. Refer to Fig 2.
- If the oil pan upper section is replaced, the oil baffle must also be replaced.
- Removing and Installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Cylinder Block
- Oil Pump Drive Chain
- Mark the running direction before removal
- Bolt
- 9 Nm
- Chain Tensioner
- O-Ring
- Replace after removing.
- Coat with engine oil
- Oil Pressure Regulation Valve -N428-
- Removing and Installing. Refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification -item : Bolt
- Oil Screen
- Oil Pump
- Removing and Installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Oil Pump Bolt
- 8 Nm +90°
- Replace after removing.
- O-Ring
- Replace after removing.
- Coat with engine oil
- Oil Intake Pipe Bolt
- 4 Nm +45°
- Replace after removing.
- Oil Pan Bolt
- Replace after removing.
- Tightening sequence. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Oil Pan Lower Section
- Removing and Installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
Oil Pan Upper Section - Tightening Specifications and Sequence
- Replace the bolts after removing them.
- Always use 18 bolts.
-- Tighten the bolts -1 through 18- in the sequence shown.
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 18- | 8 Nm |
| 2. | -1 and 2- | 180° additional turn |
| 3. | -3 to 13- | 45° additional turn |
| 4. | -14 through 18- | 90° additional turn |