Overview - Engine Oil Cooler
WARNING: This page is about a different variant/trim than selected.
- Sub-Assembly Bracket
- Removing and installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Seal
- Always replace
- O-Rings
- Always replace
- Coat with engine oil
- Mechanical Switch Valve
- Replacing. Refer to MECHANICAL SWITCH VALVE, REMOVING AND INSTALLING .
- Engine Oil Cooler
- See note. Refer to OIL PAN/OIL PUMP .
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- O-Ring
- Always replace
- Coat with coolant
- Connection
- Bolt
- 8 Nm +45°
- Always replace