Oil Spray Jets, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

CAUTION:

There is a risk of damaging the oil spray jets through distortions.

- Never bend the oil spray jets.

Fig 1: Exploded View Of Oil Spray Jet And Pressure Relief Valve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installation position: the guiding edge of the oil spray jet to the machined surface of the cylinder block.

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .