New Connecting Rod, Separating

New connecting rods might not be completely separated at the location where they should be. If the connecting rod bearing cap cannot be removed by hand, proceed as follows:

-- Mark the cylinder where the connecting rod belongs.

-- Tension the connecting rod -1- under the dotted line in a vise equipped with aluminum protective pads.

Fig 1: New Connecting Rod, Disconnecting

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen both bolts -2- approximately five turns.

-- Carefully tap against the connecting rod bearing cap in direction of -arrow- with a plastic hammer until the cap is loose.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.