Overview - Cylinder Block, Transmission Side

Fig 1: Exploded View Of Drive Plate

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Cylinder Block
2. Transmission Side Sealing Flange
   • Replace after removing.
   • Removing and installing. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
   • Clean before installing the crankshaft journal
3. Bolt
   • Tightening specification and sequence. Refer to SEALING FLANGE, REMOVING AND INSTALLING, TRANSMISSION SIDE .
4. Intermediate Plate
   • Must rest on the alignment sleeves
   • Be careful not to damage or bend when installing
   • Engaged on the sealing flange. Refer to Fig 2.
5. Alignment Sleeve
6. Bolt
   • 60 Nm +90°
   • Replace after removing.
7. Washer
8. Drive Plate
   • Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
   • It is possible to install in one position only, the holes are offset.
   • The >>collar<< faces the engine
9. Shim
   • Usage. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

Intermediate Plate, Installing 

Fig 2: Installing Intermediate Plate

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Engage the intermediate plate on the sealing flange and push it onto the alignment sleeves -arrows-.