Sub-Assembly Bracket, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

Fig 1: Identifying A/C Compressor Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Danger of frostbite from refrigerant.

- Do not open the A/C system refrigerant circuit.

-- Disconnect the connector -1- from the A/C Compressor Regulator Valve -N280-.

-- Remove the bolts -arrows-.

-- Remove the A/C compressor from the bracket with the refrigerant hoses connected and tie up to the right side. Do not bend, twist or stretch the refrigerant lines and hoses.

-- Disconnect the connectors:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1 - For the Oil Pressure Switch -F1- -2-

3 - For the Reduced Oil Pressure Switch -F378- -4-

5 - For the Piston Cooling Nozzle Control Valve -N522- -7-

-- Remove the oil filter. Refer to ENGINE OIL, DRAINING, REPLACING OIL FILTER AND FILLING .

-- Remove the bolt -1- for the oil dipstick tube.

Fig 2: Identifying Oil Dipstick Guide Tube

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the guide tube from the upper timing chain cover in the direction of -arrow-.

NOTE:

Ignore -2-.

-- Free up the wiring harness.

Fig 3: Sub-Assembly Bracket Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Place the : VAS6208 under the engine.

-- Remove the bolts -1 through 5- and pull off the accessory assembly bracket with the engine oil cooler from the coolant pump housing.

-- "Guide out" the accessories bracket between the intake manifold and engine support.