Engine Support, Removing And Installing: Removing

-- Unclip the heated oxygen sensor cable from the brackets -arrows-.

Fig 1: Locating Heated Oxygen Sensor

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the right wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Slightly lower the engine and remove the bolts -1 and 2- with : T10099  from below.

Fig 2: Engine Support - Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lift the engine again and remove the bolt -3- from the top.