Overview - Balance Shaft

WARNING: This page is about a different variant/trim than selected.

NOTE:

After performing work on the chain drive the adaptation value in the engine control module must be adapted. To do so, turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:

Engine control module, functions

0001 - Adaptation after repair work on chain drive

Fig 1: Exploded View Of Balance Shaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Bolt
- 4 Nm + 45° additional turn
- Always replace
Balance Shaft
- Replace in pairs only
- Exhaust side
- Lubricate the bearing with engine oil
- Replacing. Refer to EXHAUST SIDE BALANCE SHAFT, REMOVING AND INSTALLING .
Needle Bearing Rim
- Replace each time the balance shaft is removed
- The needle bearing rim is colored, a needle bearing rim of the same color must be installed.
Balance Shaft Pipe
- Installation position. Refer to Fig 2.
Cylinder Block
Intake Side Balance Shaft Seal
- Replacing. Refer to BALANCE SHAFT GASKET, REPLACING, INTAKE SIDE .
Balance Shaft
- Replace in pairs only
- Intake side
- Lubricate the bearing with engine oil
- Replacing. Refer to INTAKE SIDE BALANCE SHAFT, REMOVING AND INSTALLING .
Needle Bearing Rim
- Replace each time the balance shaft is removed
- The needle bearing rim is colored, a needle bearing rim of the same color must be installed.
Bolt
- 4 Nm + 45° additional turn
- Always replace

Balance Shaft Pipe Installation Position

Fig 2: Balance Shaft Pipe

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The openings -arrow- must face the chain side.