When the Water Separator in the is Filled with Coolant the Coolant Expansion Tank Must Be Extracted:
WARNING: This page is about a different variant/trim than selected.
-- Close the shut-off valve -B- and switch off the Electric Vacuum Pump --.
-- Seal the supply hose -2- and the return hose -1- of the coolant expansion tank using the : 3094 .
-- Remove the connector coupling -arrow- and open the shut-off valve -B- the coolant expansion tank is vented with this.
-- Remove the : VAS6096 and : VAS691005/5 .
-- Extract the coolant from the coolant expansion tank.
-- Reinstall the : VAS6096 and : VAS691005/5 and remove the : 3094 .
-- Switch on the Electric Vacuum Pump -- and extract again for five minutes.