Coolant Pump Toothed Belt, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the turbocharger air duct pipe/charge air cooler. Refer to TURBOCHARGER AIR DUCT PIPE/CHARGE AIR COOLER, REMOVING AND INSTALLING .

-- Remove the clip -1-, and remove the upper coolant hose and set aside.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1- from the Oil Pressure Switch -- -2-.

Fig 1: Oil Pressure Switch, Level 3 -F447- Installation Position -2-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and remove the toothed belt guard.

Fig 2: Removing Toothed Belt

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The drive gear bolt has a left-hand thread.

-- Counterhold the vibration damper and remove the bolt on the drive wheel -1- for the coolant pump and loosen three turns. Use : VAG1410 and : T10360 .

NOTE:

If on vehicles with a manual transmission a starter bolt hinders attaching the tool, remove the bolt approximately 15 mm.

-- Remove the toothed belt -2-.