LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2021 >> Atlas SEL R-Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Cylinder Head, VALVETRAIN (2.0L)) >> 15 Cylinder Head, VALVETRAIN >> Timing Chain Cover >> Timing Chain Cover, Removing And Installing >> Upper Timing Chain Cover, Removing And Installing >> Installing

Upper Timing Chain Cover, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.
Fig 1: Timing Chain Cover Tightening Sequence (1 of 2)
GWWA15-11235Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Replace the seals.

-- Install the cover on the cylinder head the tighten the bolts hand tight. While doing so make sure that the seal lays correctly on the cylinder head.

-- Tighten the bolts -1 through 6- in the sequence shown. For the bolts -3 and 5-, use the : VAG1783  and : VAG1783/1  .

-- Install the Camshaft Adjustment Valve 1 -N205- and Exhaust Camshaft Adjustment Valve 1 -N318-. Refer to Camshaft Adjustment Valve 1 -N205-, REMOVING AND INSTALLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

Tightening Specifications 

scientia non olet · About LEMON Manuals