Timing Chain, Checking

WARNING: This page is about a different variant/trim than selected.

NOTE:

If an elongated camshaft timing chain is suspected based on complaints (for example noises), the timing chain can be checked as described in the following.

-- Remove the right wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Remove the plug -arrow-. The plugs must be replaced.

Fig 1: Identifying Plug

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the vibration damper in direction of engine rotation until the chain tensioner piston is extended the maximum distance in the direction of -arrow-.

Fig 2: Identifying Vibration Damper

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Count the visible piston teeth.

NOTE:

The visible teeth are all of the teeth that are located to the right of the chain tensioner housing -arrow-.

If six or fewer splines are visible: the camshaft timing chain does not need to be replaced.
If seven or more splines are visible: the camshaft timing chain must be replaced. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .