Charge Air Pressure Actuator -V465-, ADJUSTING

Special tools and workshop equipment required 

• Mini Torque Wrench: VAS6854 
• Vehicle Diagnostic Tester

Removing 

-- Loosen the clamp -1- for the catalytic converter -2- and push the clamp on the turbocharger.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the nuts -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove bolts -arrows- and set the catalytic converter slightly aside.

-- To do so, turn on the ignition and select the following menu item on the Vehicle Diagnostic Tester:

• Engine control module, functions 
• 0001 - Charge pressure actuator V465 adjusting 

-- Adjust the charge air pressure actuator linkage to the instructions in the vehicle diagnostic tester.

-- Tighten the lock nut with the Mini Torque Wrench: VAS6854  .

Tightening Specifications 

• Refer to OVERVIEW - TURBOCHARGER