Charge Air Cooler, Removing And Installing, Golf, PASSAT, TIGUAN And ARTEON: Removing
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove the bolt -arrow- on the left and right.
-- Unclip and remove the lower section -1- of the air duct.
-- Remove the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the radiator. Refer to RADIATOR, REMOVING AND INSTALLING .
-- Lift the clamp -arrow- and remove the left upper coolant hose from the radiator.
Touran
-- Remove the right and left headlamps. Refer to HEADLAMP, REMOVING AND INSTALLING .
The bolts for the center guide are covered by the headlamps.
All Vehicles
-- If equipped, remove the center guide -A- from the lock carrier -arrows-.
-- Unclip the air guides from both sides of the lock carrier.
-- Remove the left and right radiator mount catches -arrows- with a side cutter. Push the top of the charge air cooler slightly toward the engine.
The radiator mount will be used again when installing. It is then attached to the lock carrier. Bolts. Refer to the Parts Information.
-- Loosen the hose clamps -1 and 2- and remove the right charge air hose.
-- Seal the open lines and connections with clean plugs from the :VAS6122 .
-- If equipped, unclip the air guides from both sides of the condenser.
-- Have a second technician release the clamps -1- on the left and right side in the direction of the arrow -A-. Remove the condenser -3- upward out of the mounts -B- arrows.
-- Secure the condenser to the lock carrier.
-- Remove the charge air cooler downward.