LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2020 >> Golf Standard Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Crankshaft, Cylinder Block (4-Cylinder Direct Fuel Injection (1.4L Engine, 4V, Ea211, Turbocharger)) >> 13 Crankshaft, Cylinder Block >> Crankshaft >> Crankshaft Needle Bearing, Replacing >> Installing

Crankshaft Needle Bearing, Replacing: Installing

Fig 1: Identifying Bearing Press Piece
GWWM13-10009Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

On open bearings, the side of needle bearing with writing on it must be readable when installed. Drive in the one sided closed bearing using the closed side in the correct crankshaft.

-- Clean the bearing seat in the crankshaft and thinly coat with grease.

-- Drive the needle bearing into the crankshaft up to the installation depth using the : VW207C  .

Installation depth dimension a = 2.0 mm

Fig 2: Identifying Installation Depth
GWWM13-10031Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
NOTE:

If the needle bearing was unintentionally driven in too deeply, it must be replaced, because it will be damaged when it is removed again.

-- Install the transmission. Refer to TRANSMISSION, INSTALLING .

scientia non olet · About LEMON Manuals