Charge Pressure Actuator -V465-, ADJUSTING

WARNING: This page is about a different car, the 2021 Volkswagen GTI, 2020 Volkswagen GTI, 2019 Volkswagen GTI, 2018 Volkswagen Golf, and 2018 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Mini Torque Wrench: VAS6854
Vehicle Diagnostic Tester

Removing

NOTE:

Ignore item -4-.

-- Remove the bolt -2- and the screw-type clamp.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the nuts -1 and 3-.

-- Remove bolts -arrows- and set the catalytic converter slightly aside.

Fig 1: Identifying Exhaust System Bracket (Suspended Mount) Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn on the ignition and select the following menu items on the Vehicle Diagnostic Tester:

01 - Engine Electronics
Guided Functions
01 - Charge Pressure Actuator V465 Adjusting

-- Adjust the charge pressure actuator linkage to the instructions in the Vehicle Diagnostic Tester.

-- Tighten the lock nut with the Mini Torque Wrench: VAS6854 .

Tightening Specifications

Refer to OVERVIEW - TURBOCHARGER .