LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2020 >> Golf Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Assembly (4-Cylinder Direct Fuel Injection (1.4L Engine, 4V, Ea211, Turbocharger)) >> 10 Engine Assembly >> Assembly Mounts >> Assembly Mount, Adjusting

Assembly Mount, Adjusting

Procedure 

-- Remove the battery tray. Refer to BATTERY TRAY, REMOVING AND INSTALLING .

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Remove and replace the bolts -arrows- for the engine mount one after the other (if this was not already done when the engine was installed).

Fig 1: Identifying Engine Mount Bracket Bolts
GWWN10-0437Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts loosely.

-- Remove the bolts -arrows- for the transmission mount -1- one after the other and replace them (if this was not already done when the engine was installed).

GWWA34-11053Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts loosely.

-- Slide the engine/transmission assembly with an extractor lever until the following dimensions are set:

Fig 2: Identifying Distance And Dimension
GWWA10-11628Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.

The casting edge on the engine support -2- must be parallel to the engine mount support arm -1-.

Dimension -b- = dimension -b-.

NOTE:

Distance -a- = 10 mm can also be checked for example using a suitable round stock.

-- Tighten the bolts on the engine mount.

-- Make sure that the edges of the support arm -2- and the transmission support -1- are parallel on the transmission side.

GWWA10-11580Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the transmission mount bolts.

Install in reverse order of removal.

Tightening Specifications 

scientia non olet · About LEMON Manuals