Camshaft Seal For Transmission Side Exhaust Camshaft, Removing And Installing: Installing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If necessary, remove any burrs in the outer area of the grooves on the exhaust camshaft -arrows- using fine-grain 220 to 1000 sandpaper.

• Do not coat the new seal with oil.

-- Slide the seal -1- over the : T10479/3  in direction of -arrow- and onto the : T10479/2  in direction of -arrow-.

Fig 1: Identifying Fitting Sleeve And Guide Sleeve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Installed position: the closed side of the seal faces the seal installer.

-- Separate the fitting sleeve and guide sleeve.

-- Position the Guide Sleeve : T10479/2  with the seal -2- in the center on the camshaft.

Fig 2: Identifying Guide Sleeve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the guide sleeve to the camshaft with the coolant pump drive wheel bolt -1-.

-- Push the seal onto the camshaft and remove the guide sleeve.

-- Install the seal -2- with the : T10479/1  and the bolt -1- for the coolant pump drive wheel all the way.

Fig 3: Identifying Thrust Piece

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the coolant pump toothed belt. Refer to COOLANT PUMP TOOTHED BELT SPROCKET, REMOVING AND INSTALLING .