Overview - Camshaft Housing, Vehicles Without Adjustable Exhaust Camshaft

Fig 1: Camshaft Housing, Vehicles Without Adjustable Exhaust Camshaft Exploded View

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Bolt
   • Tightening specification and sequence. Refer to Fig 2.
   • Different lengths installed
2. Camshaft Adjustment Valve 1 -N205-
   • Removing and installing. Refer to Camshaft Adjustment Valve 1 -N205-, REMOVING AND INSTALLING .
3. Bolt
   • 8 Nm
4. Camshaft housing
   • Removing and installing. Refer to CAMSHAFT HOUSING, REMOVING AND INSTALLING .
5. Camshaft Position Sensor -G40-
   • Removing and installing. Refer to Camshaft Position Sensor --, REMOVING AND INSTALLING .
6. Bolt
   • 8 Nm
7. Seal
   • Always replace after removing. Refer to CAMSHAFT SEAL FOR TRANSMISSION SIDE EXHAUST CAMSHAFT, REMOVING AND INSTALLING .
   • For the exhaust camshaft on the transmission side
8. Toothed Belt Sprocket
   • For the coolant pump
   • Removing and installing. Refer to COOLANT PUMP TOOTHED BELT SPROCKET, REMOVING AND INSTALLING .
9. Bolt
   • Tightening specification. Refer to -item 8) Bolt .
10. Bolt
    • 8 Nm
11. Cap
12. O-ring
    • Always replace after removing.
13. Seal
    • Always replace after removing.
14. Alignment Pin
15. Seal
    • With oil strainer
    • The oil screen may only be installed if the cylinder head has the corresponding recess for it.
    • Cylinder heads without a recess do not require an oil screen.
    • Installed in the cylinder head
16. Seal
    • Always replace after removing. Refer to CAMSHAFT SEAL FOR INTAKE CAMSHAFT, REMOVING AND INSTALLING, BELT PULLEY SIDE .
    • For the intake camshaft
17. Seal
    • Always replace after removing. Refer to CAMSHAFT SEAL FOR EXHAUST CAMSHAFT ON BELT PULLEY SIDE, REMOVING AND INSTALLING .
    • For the belt pulley side exhaust camshaft
18. Cap

Camshaft Housing - Tightening Specification and Sequence 

Fig 2: Camshaft Housing Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

1. Bolts -1 to 4- : M 6 x 52
2. Bolts -5 to 15- : M 6 x 65

-- Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps shown in the sequence.