LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2020 >> Golf Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Crankshaft, Cylinder Block (4-Cylinder Direct Fuel Injection (1.4L Engine, 4V, Ea211, Turbocharger)) >> 13 Crankshaft, Cylinder Block >> Pistons And Connecting Rods >> Pistons, Removing And Installing >> Installing

Pistons, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Replace the bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston with a commercially available piston ring compressor. Pay attention to the installed position Figure.

-- Install the connecting rod bearing cap. Pay attention to the installation position -item  ) Connecting Rod Bearing Cap.

-- Install the cylinder head CYLINDER HEAD, REMOVING AND INSTALLING .

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals