Headlamp, Removing And Installing: Installing

Install in reverse order of removal and note the following:

-- Slide the headlamp into the bumper cover guide.

-- Uniformly adjust the headlamp gap distribution. Refer to HEADLAMP INSTALLATION POSITION, CORRECTING .

-- Push on the bumper cover -1-. Pay attention that it is pushed in the mounts -2- under the headlamp.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If a new LED Headlamp Power Output Module A32/A27 is installed, the control module replacing function and the "initial operation" function, must be performed in the guided functions or guided fault finding.

-- Perform a function test.

-- Check and correct headlamp adjustment, if necessary.