Brake Shoes &/Or Pads: Remove & Replace
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front or Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed Brake System. | ||||
| Each Additional | 0.2 | B | ||
| One | 0.4 | B | ||
| Combination Procedure: CALIPER: Overhaul: Includes: Bleed System. | ||||
| One | 0.5 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed System. | ||||
| One | 0.8 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Parking Brake Service Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. | 0.3 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: WHEEL BEARING: Replace: Includes: Repack Bearings (where applicable). | ||||
| AWD, Rear,Both Sides | Includes: R&I Drive Axle. | 4.2 | B | |
| AWD, Rear,One Side | Includes: R&I Drive Axle. Includes: R&I Muffler. | 2.6 | B | |
| Front,Both Sides | 3.3 | B | ||
| Front,One Side | 2.0 | B | ||
| Combination Procedure: WHEEL CYLINDER: Overhaul: Includes: Bleed System. | ||||
| Off Vehicle,One | 0.8 | B | ||
| On Vehicle,One | 0.6 | B | ||
| Combination Procedure: WHEEL CYLINDER: Replace: Includes: Bleed System. | ||||
| One Side | 0.6 | B | ||