Tire Pressure Monitoring Sensors -G222- / -G223- / -G224- / -G225-, Removing And Installing: Installing

CAUTION:

Always replace the entire metal valve.
Clean the valve opening before installing the Tire Pressure Monitoring Sensor --.

-- Pre-mount the Tire Pressure Monitoring Sensor -- loosely with the square head screw -5- on the metal valve -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Make sure the metal valve is not screwed tightly onto the sensor.

-- Insert the metal valve into the rim valve block.

CAUTION:

Do not counterhold on the metal valve when tightening
A washer in the union nut -2- causes the metal valve to be bolted down first to the Tire Pressure Monitoring Sensor -- when tightening. After the washer breaks, the Tire Pressure Monitoring Sensor -- will be bolted to the rim.

-- Screw the new union nut on the metal valve. At the same time the metal valve is turned and is attached to the Tire Pressure Monitoring Sensor --.

-- Tighten the union nut over the tangible break in the ruptured washer to the tightening specification.

-- Install the tire on the rim. Refer to TIRES, DISMOUNTING .