Front Three-Point Seat Belt, Removing And Installing: Installing
- Observe the safety precautions for pyrotechnical components SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
Install in reverse order of removal and Note The Following:
-- If parts of the seat belt system are removed due to an accident, replace the belt system bolts.
Make sure the connectors are pushed in all the way and that they engage audibly.
-- Insert the automatic belt retractor with the anti-twist mechanism -1- in the mount -2- -arrow- and tighten the bolt.
-- Attach the connector -1- to the igniter -arrow A-.
-- Push in the connector lock -2- -arrow B-. While doing so, the connector is pushed all the way into the igniter and locks into place at the same time.
The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.
-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
If the ignition is not switched on after the battery is reconnected - "indicator lamps in the instrument cluster do not light up" - the ignition (key/button) may only be switched on when the driver seat is positioned all the way back.