Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING: Removing
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the bumper cover. Refer to FRONT BUMPER COVER, REMOVING AND INSTALLING / REAR BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the bolt -3-, and remove the Pedestrian Protection Center Crash Sensor -G693- -item 1- from the bumper.
-- Disconnect the connector -2-.
WARNING:
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- To do this pull out the connector lock -2-, push down -arrow-, and disconnect the connector -1- on the crash sensor.