Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770-, CALIBRATING
Special tools and workshop equipment required
- Calibration Unit: VAS6350A
- Vehicle Diagnostic Tester
- Calibration Tool - Lane Change Calibration Tool: VAS6350/4
Before starting the actual calibration procedure for the control modules, the : VAS6350A must be set up as described in the service information.
The following should not occur during the calibration procedure:
- Vehicle doors must not be opened or closed.
- People must not sit in the vehicle.
- People must not go between the vehicle and the : VAS6350/4 .
Procedure:
-- Turn on the : VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
If the red LED -2- turns on: check the : VAS6350/4 .
-- Connect the Vehicle Diagnostic Tester.
-- Select calibration in the "Guided Fault Finding" . Refer to Vehicle Diagnostic Tester.
-- Follow the instructions in the Vehicle Diagnostic Tester display.
-- Turn off the : VAS6350/4 and reposition the calibration tool.
During the program sequence, there is a prompt to switch the : VAS6350/4 from the left to the right side of the : VAS6350A .
- When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).
- Dimension -a- = 744 mm (measured from the upper edge of calibration device to the floor).
- Right adjustment dimension = 769 mm (read on measuring scale -1-).
-- Turn on the : VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
-- Follow the instructions in the Vehicle Diagnostic Tester display.
After successfully calibrating the lane change assistance, switch off the ignition and disconnect the diagnostic connector.