Converter with Socket, 12 V-230 V -U13-, REMOVING AND INSTALLING

Special tools and workshop equipment required

WARNING:

There is a danger of electric shock.

The Converter with Socket, 12 V-230 V -U13- housing contains capacitors that can be charged with residual voltage.
The Converter with Socket, 12 V-230 V -U13- housing must not be opened under any circumstances.
No repairs may be performed on the connector, on the wires and the 230 V socket.
If there is a connector, wire, 230 V socket or converter malfunction, always replace the entire unit.

Removing

-- Switch off the ignition.

-- Move the ignition key outside of the vehicle to prevent the ignition from switching on unintentionally.

-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Release and disconnect the connector for the 12V input voltage.

-- Free up the wire -2 and 3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -4-.

-- Remove the Converter with Socket, 12 V-230 V -U13- -1- with the bracket in the direction of -arrow- from the center console.

-- Remove the bolts -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the Converter with Socket, 12 V-230 V -U13- -1- from the bracket -2-.

Installing:

Install in reverse order of removal and note the following:

Tightening Specifications