Fuel Tank, Draining When Less Than 3/4 Full: Notes
Special tools and workshop equipment required
- Trim Removal Wedge:3409
- Wrench - Fuel Sending Unit:T10202
- Torque Wrench 1332 40-200Nm:VAG1332
- Fuel Extraction:VAS5190
- Fuel Extraction:VAS5190
-- Attach the ground wire of the :VAS5190 to a bare area on the body.
-- Remove the bench seat. Refer to REAR SEATS .
-- Remove the carpet and fold it upward.
-- If equipped, remove the Fuel Pump Control Module -J538- -2- from the right cover.
-- Unclip the right cover -1- at the tabs in direction of -arrows- using the :3409 .
-- Disconnect the connector -1- from the fuel delivery unit.
The fuel system is under pressure.
Risk of injury from fuel spraying out.
- Wear protective eyewear.
- Wear safety gloves.
- Reduce the pressure: place clean cloths around the connection point and carefully open the connection point.
-- Remove the fuel line -2- from the fuel delivery unit flange -3-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
-- Open the locking ring using the :T10202 .
-- Do not bend the :T10202 and push hard on the locking ring. If the wrench slides down, the fuel delivery unit can be damaged.
-- Lift the flange.
-- Insert the suction hose as far as possible into the fuel tank and extract the fuel.
If fuel tank only needed to be emptied, install the flange again.