FUNCTION AND POWER SUPPLY, CHECKING, VEHICLES WITHOUT Fuel Pump Control Module -J538-: Notes

Special tools and workshop equipment required 

• Vehicle Diagnostic Tester - Test Adapter - 5 Pin:VAS5565 
• Trim Removal Wedge:3409 
• Multimeter, for example Analog/Digital Multimeter:FLU83III 
• Connector Test Set:VAG1594D 
• Vehicle Diagnostic Tester

Test Conditions: 

• The battery voltage must be at least 11.5 V. Charge if necessary. Refer to BATTERY .
• Fuse for the Transfer Fuel Pump -G6- is OK. Refer to appropriateWiring Diagram .