Spark Plugs, Replacing, 1.8L And 2.0L TSI Engine: Removing

-- Remove the engine cover. Refer to "Upper" ENGINE COVER, REMOVING AND INSTALLING .

Fig 1: Identifying Ground Wire

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If equipped remove the ground wire -arrows-.

-- Disengage the connectors -1 through 4- and at the same time remove all of the plugs from the ignition coils with the power output stage.

Fig 2: Disconnecting Ignition Coils Connectors

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the ignition coils with the power output stage bolts.

-- Push the :T10530  until stop in the ignition coil opening -1-.

Fig 3: Identifying Puller T10530

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the knurled nut -2- in the direction of the -arrow-.

-- Pull the ignition coil on the :T10530  in the direction of the -arrow- out of the cylinder head cover.

Fig 4: Identifying Puller T10530

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Repeat the procedure for all ignition coils with power output stage.

-- Remove spark plugs using :3122B  .