SERVICE INTERVAL DISPLAY, RESETTING WITH Vehicle Diagnostic Tester
WARNING: This page is about a different variant/trim than selected.
NOTE:
If the displays indicated in the procedure are not shown on the display. Refer to the Vehicle Diagnostic Tester Operating Instructions.
| ODIS Service |
|---|
| -- Connect the Vehicle Diagnostic Tester. Refer to Vehicle Diagnostic Tester . |
| -- Switch on the ignition. |
| -- Perform the vehicle identification. |
| -- Select "Work with guided fault finding" |
| -- Select the "control module" |
| -- Select "Instrument Cluster" |
| -- Select "identify control module". |
| -- Select "Guided Functions". |
| -- Select the corresponding service that is to be reset. |
| -- Perform the adaptation according to the "Guided Functions". |