DTC MEMORY FOR ALL SYSTEMS, READING WITH Vehicle Diagnostic Tester AND CORRECTING FAULTS ACCORDING TO REPAIR PROCEDURE
WARNING: This page is about a different variant/trim than selected.
Procedure
NOTE:
If the displays indicated in the procedure are not shown on the display, refer to the Vehicle Diagnostic Tester Operating Instructions.
| ODIS Service |
|---|
| -- Connect the Vehicle Diagnostic Tester. Refer to Vehicle Diagnostic Tester . |
| -- Switch on the ignition. |
| -- Perform the vehicle identification. |
| -- Enter the order data or select "no order". |
| -- Select "control module". |
| -- Select "DTC memory list" |
| -- Correct any faults according to the repair procedure. |
CAUTION:
In every case, the vehicle must be released to the customer with the DTC memory erased.
Static Errors
If one or more static malfunctions exist in the DTC memory, we recommend in agreement with the customer, that these malfunction be resolved with the help of Guided Fault Finding.
Sporadic Errors
If only sporadic errors or notes are stored in the DTC memory and the customer has no concerns regarding an electronic vehicle system, delete the DTC memory.