LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (Instruments (Convertible)) >> 90 Instruments >> Accessories >> Accessories, Removing And Installing >> Removing

Accessories, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Remove the Information Electronics Control Module 1 -J794-. Refer to INFORMATION ELECTRONICS CONTROL MODULE 1 -J794-, REMOVING AND INSTALLING (CONVERTIBLE) .

-- Remove the bolts -arrows- and remove the accessories and the cover -1- upward from the instrument panel.

Fig 1: Identifying Bolts And Cover
GWWM90-10006Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and disconnect the connector.

-- Remove the bolts -arrows- from the cover -2- and then remove the accessories -1- from the cover -2-.

Fig 2: Identifying Bolts
GWWM90-10009Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.