Turn Signal Switch -E2-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different variant/trim than selected.

When Reusing the Steering Column Combination Switch:

-- Slide the steering column combination switch into the guide on the base carrier.

-- Install and tighten the bolt.

On a New Steering Column Combination Switch:

-- Install the steering lock housing -3- in the base carrier -2-.

Fig 1: Identifying Steering Column Switch Components

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Slide the pre-assembled unit from the steering lock housing, base carrier and the steering column combination switch all the way onto the steering column and line them up with the threaded holes.

-- Attach the steering lock housing -3- to the steering column with new shear bolts -1-.

-- Tighten the new shear bolts -1- until the bolt heads shear off.

Continuation for New and Reused Steering Column Combination Switch:

Install in reverse order of removal.