Steering Column Electronics Control Module -J527-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
CAUTION:
The return lever on the Turn Signal Switch -E2- could break off when installing the Steering Column Electronics Control Module -J527-.
The Turn Signal Switch -J527- must be in the 0 position when installing the Steering Column Electronics Control Module -E2-.
-- Before sliding the Steering Column Electronics Control Module -J527- -3- the following must be checked.
- The "arrows" -1- must align.
- The spiral spring -2- must be seen in the window between the "arrows" -4-.
-- Make sure that all connectors are installed securely.