High-Mounted Brake Lamp, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Trim Release Lever:T10039
- Hot Air Blower: VAG1416
- Adhesive Strip Remover: VAS6349
- Hook:T10538
If one of the LEDs in the High-Mounted Brake Lamp Bulb -M25- is Faulty:
- The individual LEDs in the High-Mounted Brake Lamp Bulb -M25- are in groups of four and are supplied with electricity as a group.
- The High-Mounted Brake Lamp Bulb -M25- is designed in such a way that it still meets legal requirements when one LED group fails.
- If another LED group fails, these legal requirements are no longer met.
- When one LED group fails, the intact LEDs are given a higher load, by which failure of other LED groups can be assumed in the near future.
- Replace the High-Mounted Brake Lamp Bulb -M25- (Repair Procedure) if more than four separate LEDs have burned out in the High-Mounted Brake Lamp Bulb -M25-.