Low Beam Headlamp Bulb, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
CAUTION:
There is a risk of damaging the headlamp.
- Do not touch bulb glass of bulb with bare fingers. Fingers will leave traces of grease on the bulb glass which, when the bulb is switched on, will evaporate and cloud the bulb glass.
- Use clean cloth gloves to insert the bulbs.
- During installation, ensure proper seating of the housing cover. Water getting in the headlamp will cause damage.
-- Insert the Left Low Beam Headlamp Bulb -M29- into the headlamp and lock it with the wire clip.
-- Install the headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .
-- Check the headlamp functions.
-- Check the headlamp adjustment and adjust the headlamp. Refer to HEADLAMP, ADJUSTING .