Left/Right Hid Headlamp Bulb -L13- / -L14-, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while noting the following:
CAUTION:
- Do not touch the bulb glass when installing a bulb. Fingers will leave traces of grease on the glass which, when the light is switched on, will evaporate and cloud the bulb glass.
- The bulb glass of the HID headlamp must not be exposed to any mechanical strain. The bulb glass is extremely sensitive and is also under high pressure.
- Avoid looking directly into the light beam, since the UV rays given off by the HID lamp are approximately 2.5 times stronger than those of a halogen bulb.
- During installation, ensure proper seating of the cap. Water getting in the headlamp will cause damage.
NOTE:
Installation position: the electrical connection points downward.
-- Install the headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .
-- Check the headlamp functions.
-- Check the headlamp adjustment and adjust the headlamp. Refer to HEADLAMP, ADJUSTING .