Headlamp, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

-- Connect and lock the connector -2- to the headlamp.

Fig 1: Identifying Guides

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the headlamp on the guides -1- and "carefully" slide it in all the way till it stops.

-- Turn the screwdriver -1- about 50 degrees in the opposite direction of the -arrow- in order to lock the headlamp.

Fig 2: Turning Screwdriver 50 Degrees

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The headlamp is locked when the "click" noise is heard.

-- Make sure the gap dimensions are even in the headlamp installation position.

If the gap dimensions are uneven, then adjust the headlamp installation position. Refer to HEADLAMP INSTALLATION POSITION, CORRECTING .

-- Check the headlamp functions.

-- Check the headlamp adjustment and adjust the headlamp. Refer to HEADLAMP, ADJUSTING .