Access/Start System Antenna in Rear Bumper -R136-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different variant/trim than selected.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Press the detents outward and pull the Access/Start Authorization Antenna in Rear Bumper -R136- -1- out of the holder, while paying attention to the wires that are still connected.
-- Release and disconnect the connector and remove the Access/Start System Antenna in Rear Bumper -R136- -1-.