Parallel Parking Assist Bracket, Installing
Special tools and workshop equipment required
- PDC Holder Tool Set: VAS6614B
- Thermal Clip Bonder Kit : VAS6872
- Thermal Clip Bonder Kit - Hand Set: VAS6872/1
- Thermal Clip Bonder Kit - Clip, M-shaped: VAS6872/3
Bracket, Installing
After the bumper cover is painted, install the brackets.
The four markings for the bracket -1- are found on the inside of the bumper cover.
-- Drill the holes from the inside outward with the drill -3- supplied in the tool kit.
-- Position the hole stamper with the bolt head -1-, washer -2- and counterholder -3- on the inside of the bumper cover -5-.
-- Position the iron punch -4- almost up to the bumper cover.
-- Push the iron punch -4- onto the bumper cover.
-- Tighten the hole stamper -1-.
The iron punch -4- must not rotate on the bumper cover paint.
-- By turning at the bolt head -1-, the iron punch -4- is pulled through the bumper cover material -5- -arrows-.
-- Remove the hole stamper and stamp the next holes.
The spacer on the device must be set very precisely.
If the setting is too low, then the bracket will not be secured correctly.
If the setting is too high, marks from the clips will accumulate on the bumper cover.
Four clips are placed on each side. Refer to the image for the positions.
Attach three clips if the clips have beveled sides.
-- Secure the : VAS6872/3 in the : VAS6872/1 in direction of -arrow a-.
-- Set the distance -a- to exactly 3 mm.
-- Secure the bracket -2- using : VAS6614/7 or : VAS6614/6 to the hole in direction of -arrow b-.
-- Let the clips melt down without pressure in direction of -arrow C-. Switch the device off when the spacer is attached.
-- Let it cool down for 10 seconds. Do not move the device during this.
-- Remove the device after the cool-down time position the next clip.
-- Cut off the ends of the clips after all of the clips are positioned.