General Description - Refrigerant Circuit Components: Condenser

WARNING: This page is about a different variant/trim than selected.

The condenser -A- conducts heat from compressed refrigerant gas to the surrounding air.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
This condenses the refrigerant gas to fluid.

NOTE:

Depending on the refrigerant circuit design, the receiver/dryer is installed (integrated) either on the condenser or inside the condenser. Refer to REFRIGERANT CIRCUIT (vehicle-specific service information) and the service information.

The condenser is available in different versions and can be differentiated only by the part number on the outside. For version -1-, the condenser is divided into two areas "2 way condenser". For version -2-, the condenser is divided into four areas "4 way condenser".

Fig 1: Identifying Condenser With Fluid Reservoir Installed

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

This illustration shows a condenser with the receiver/dryer -C- installed.

The gaseous refrigerant enters at the connection -A- into the condenser. The refrigerant is then cooled inside the condenser and becomes fluid.

The liquid refrigerant collects in the receiver/dryer -C- (with dryer) and flows through the lower cooling area towards the connection -B- .

Depending on the design of the condenser (interior volumes, delivery flow, etc.), the refrigerant capacity in a refrigerant circuit may vary. For this reason always pay attention to the correct version and allocation of the condenser. Refer to TECHNICAL DATA (vehicle-specific service information) and the service information.