LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Mechanical Components (Brake) (Convertible)) >> 46 Mechanical Components >> Rear Brakes >> Brake Rotor, Removing And Installing >> Installing

Brake Rotor, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

NOTE:

Carefully clean before installing.

Check the brake rotors for wear, damage, dimension and damaged threading.

Replace on both sides of axle if worn.

-- Thoroughly clean the contact surfaces for the brake pads on the brake carrier and remove any corrosion.

If using the brake pads again, install the marked pads in the same location.

-- Secure the brake caliper with new self-locking bolts. Refer to the Parts Information.

NOTE:

With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.

Check the brake fluid level.

-- Install the wheel and tighten.

scientia non olet · About LEMON Manuals