LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2018 >> Beetle S, 2D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Mechanical Components (Brake) (Convertible)) >> 46 Mechanical Components >> Rear Brakes >> Brake Carrier, Removing And Installing >> Installing

Brake Carrier, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Install in reverse order of removal. Note the following:

-- Thoroughly clean the contact surfaces for the brake pads on the brake carrier and remove any corrosion.

If using the brake pads again, install the marked pads in the same location.

-- Secure the brake caliper with new self-locking bolts. Refer to the Parts Information.

NOTE:

Each time after replacing brake pads, depress brake pedal several times firmly to properly seat brake pads in their normal operating position.

Check the brake fluid level after removing the brake pads.

-- Install the wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

scientia non olet · About LEMON Manuals