Overview - FS III
WARNING: This page is about a different variant/trim than selected.
- Install the entire repair kit when servicing.
- Only use mineral spirits to clean the brakes.
- Apply a thin coat of Assembly Paste to brake cylinders, pistons and seals.
- Dust Cap
- Attach to bleeder valve
- Breather Valve
- 10 Nm
- Lightly grease the threads with Assembly Paste before installing.
- Caps
- Insert in bushing
- Guide Pin
- 30 Nm
- Bearing Bushing
- Insert in brake caliper
- Brake Caliper
- Removing and installing. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, BRAKE CALIPER FS III .
- Cap
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING, FS III .
- Do not damage when inserting the piston
- Piston
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING, FS III .
- Apply a thin coat of Assembly Paste to piston beforehand
- Seal
- Removing and installing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING, FS III .