Brake Caliper Piston, Removing And Installing, FS III: Removing

-- Remove the brake caliper. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, BRAKE CALIPER FS III .

-- Use compressed air to push the piston out of the brake caliper.

Place a Wooden Board into the Recess So the Piston Is Not Damaged.

Fig 1: Identifying Brake Caliper Housing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cap from the brake caliper using the : 3409  .

Fig 2: Identifying Protective Cap Pried Off From Brake Caliper With Trim Removal Wedge 3409

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the gasket using the : 3409  .

Fig 3: Identifying Removal Of Brake Caliper Seal With Wedge 3409

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

When removing, make sure that the cylinder surface is not damaged.